The physical cub that we got from the cube was 1 inch by 1 inch by 1 inch. the small square holes on each face of the cube is 1/2 inch by 1/2 inch making the remaining amount around the holes 1/4 inch. As for the ball, we guessed that the ball has a 1/2 inch diameter because it looked like it lined up perfectly with the hollowed out square on each side.
On TinkerCAD, the dimensions all the dimensions seemed to be halved, so the whole cube is 1/2 inch by 1/2 inch.
This bottle opener design is similar to out with the finer hole on the back end and the hook on the opposite side. The only real difference is the hooking action our is more of a pull while this design is a hooking or pushing. When deconstructing and ungrouping this design had a lot more holes and cuts while in comparison, our design is set up with more shapes and fewer holes.
No comments:
Post a Comment